Pro tip: G54 or G55 for a second vise on the same table?

Last week I set up two vises on my Haas VF2, and I had to pick between keeping both on G54 and just offsetting the second one on its own work offset, or going with G54 and G55 as separate offsets. I went with separate offsets for each vise, and it made tool changes and re-zeroing way cleaner after a fixture bump. Anyone else run two vises on one table, and do you keep them on one offset or split them like I did?

0 comments

Log in to join the discussion

Log In

0 Comments

No comments yet

Be the first to share your thoughts on this discussion.