Loading…
22
G54 or G55 for a second vise on the same table? I keep going back and forth
I stopped re-zeroing my second vise every setup by touching off once and saving it as G55 six months ago, and my scrap rate on the Haas went from about 4 parts a month to zero. My lead man says that's lazy and you should re-probe every job in case someone bumps the vise. Curious where you all land on this, do you trust a saved offset or probe it fresh every time?
0 comments
Log in to join the discussion
Log In0 Comments
No comments yet
Be the first to share your thoughts on this discussion.