Loading…
4
A retired sweep in Boise told me my brush was too soft for creosote, so I swapped to poly and the difference showed up on the very next job
I was running a wire brush on everything for about 4 months because it felt like it scraped harder, then a retired sweep in Boise watched me pull a flue and said 'you're polishing that glaze, not cutting it.' I switched to a poly brush on a drill for stage 3 creosote and pulled out chunks I had been glazing over on the same flue type. What brush setup are you all running for heavy glaze, or do you just hand scrape and hope for the best?
0 comments
Log in to join the discussion
Log In0 Comments
No comments yet
Be the first to share your thoughts on this discussion.